GO TO INDEX

Blue Point Manual Turnout Controller    Blue Point Flex Link Starter Kit & Parts    Complete Blue Point Installation Instructions
Universal Throttle Pockets    Folding Drink Cup & Tool Holders

BLUE POINT FLEX LINK STARTER KIT AND PARTS

Finally we're providing everything you need to connect your Blue Point™ turnout controller to a knob on the fascia, even if your Blue Point™ isn't aligned at a right angle to the fascia.

Flex Link™ Starter Kit

The starter kit contains everything you need for one Blue Point™:

• 1ea  knob, pre-drilled
• 1ea  2-56 screw & washer to attach the knob to the inner tube
• 1ea  3 ft Flex Link™ tube (contains both an inner and outer tube)
• 2ea  tube clamps with screws, anchors the outer tube at each end
• 1ea  steel bracket to hold the outer tube at the Blue Point™ end
• 1ea  2-56 threaded rod and clevis to attach inner tube to Blue Point™.

We've designed this kit so you can try out the Flex Link™. The other two products are designed to handle multiple installations.

Flex Link™ Hardware Kit

This package includes enough hardware to hook up five Blue Points™. It contains everything you need except for the tubing. Why do we have the tubing separate? Because you can cut the tubing into shorter lengths so you can hook up more Blue Points™.

Flex Link™ Tubing

This contains five sets of 3-foot flexible tubes. As mentioned above, you can cut these shorter if you have turnouts closer to the fascia so five sets of tubing can be enough for 5, 10, or even more turnouts, depending on the length needed to reach each turnout.

Picture shows you method used to lengthen tubing
to desired length by using threaded stud #40051. Make sure red tubing covers the joint.
Also additional hold down clamps #40057 should be used.

Pricing